|Category||Farming Simulator 2011|
|Joshua Branson (Unknown)||30.04.2011 08:20|
|I was wondering some things about the xml file.
Firstly in the 'components' there is a 'solverIterationCount' What is this?
And what units are used to measure capacity, and the radius of the wheels?
|Stefan Geiger - GIANTS Software||24.06.2011 09:04|
|The solverIterationCount determines the quality of the physics simulation of that object. Increasing this value also increases the time complexity and results in a higher CPU load. So you should start with a small value such as 4. If created a tool with a lot of joints and you can't get a stable result even after tuning the masses and centers of mass, you can try to increase this value (maybe at most up to 15), and see if it helps to improve the simulation.
The Capacity is measured in liters and the radius of wheels is in meters.
|Joshua Branson (Unknown)||30.06.2011 10:10|
Note: Log in to post. Create a new account here.