Community Forum

Group cloning & camera location

Forum Overview >> Editor

Created16.02.2012 14:58

Daniel Wire (Unknown) 16.02.2012 15:10
When I clone a transform group, the camera (x, y, z location arrows?) is located so far away from my clone that it is impossible to locate the clone with any precission. I've tried the move-to-camera, framed located, interactive placement. Sometimes the cloned group appears at the bottom of the sea, miles from where it's needed. I'm sure there is some little trick that I'm missing, but I haven't been able to figure it out. If anyone could provide some insight, it would be greatly appreciated.


Yan Belousov (Unknown) 18.07.2012 22:52
try to use windows hot keys ctrl+c and ctrl+v

Note: Log in to post. Create a new account here.