| Category | Editor |
| Created | 17.03.2015 22:04 |
| Ismael Artacho Angel (Unknown) | 17.03.2015 22:07 |
|---|---|
| Hi, I create 3 new splines, but show this error: Error: Traffic system road spline 'Curve_l' dead-end found at XXXXXX Error: Traffic system road spline 'Curve_rot' dead-end found at XXXXX The head and end have the same position exactly as the next or previous spline (E->S), why show this error? |
|
| Emil Drefers (Unknown) | 18.03.2015 09:23 |
|---|---|
| Hi, you are right, the end of one spline mus be close to the start of an other spline. If the start of the next spline is too far away from the end of the first spline the shown error message appears. A further requirement is that the end of every spline must be close to the start point of an other spline. This means, that the vehicles/pedestrians must be able to walk "in circles" ... they can't walk into a dead end. Cheers, Emil |
|
| Ismael Artacho Angel (Unknown) | 22.03.2015 20:45 |
|---|---|
| Thanks, I fix mistake. The transform group with splines was inside another tarnsform group and the two had attribute with oncreate, xmlfile,... :) thanks for your attention. |
|
Note: Log in to post. Create a new account here.