Forum Overview >>
Editor
| Category | Editor |
| Created | 01.01.2022 02:24 |
| Gregg Macfarlane (SirCuddlesWorth) |
01.01.2022 02:24 |
|---|
So I have the traffic working fine, but I want to change the speed limit in certain zones or back roads, and before I had it locked in a loop with O and it spawns and runs fine.
But then I try to link more like side roads at a lower speed it throws this error. "Error: Traffic system road spline 'slowTurn01' dead-end found at 212.118713 -7.738867. I used an example from the mapUS and it has separate road splines that are not connected to the main one, so what am I missing? I tried to move it right on top of the other spline, I tried moving the S End on top of the red square on the main spline, nothing works.
I cant press S to stitch it because nothing happens. Any help would be appreciated. Hope you all have a good 2022.
|
| Ed Propsner (crotchfrog) |
02.01.2022 18:55 |
|---|
If your spline is under "trafficSystem" it needs to be in a closed loop. If you do have it in a closed loop, the end of one spline and the start of another need to be as close to each other as you can get them. A dead end is telling you there is a break in the loop at the provided coordinates.
|
| Gregg Macfarlane (SirCuddlesWorth) |
03.01.2022 07:30 |
|---|
@Ed Propsner (crotchfrog) Thanks for the reply, I got it working now. Apparently pressing O when t's a foot away don't count. Picky lol.
|
Note: Log in to post. Create a new account
here.