| Category | Blender Exporter |
| Created | 05.03.2017 22:18 |
| Gerrit Geldenhuys (Unknown) | 05.03.2017 22:20 |
|---|---|
| Hi All. I turned off "Backface Culling" but after exporting I still see through the back off some faces. Any Help please... |
|
| David Zadnik (DzInLa) | 06.03.2017 23:05 |
|---|---|
| GIANTS EDITOR will only show one side of a face, that's why the guide says to have "Backface Culling" ON while editing in BLENDER. |
|
| Gerrit Geldenhuys (Unknown) | 08.03.2017 19:28 |
|---|---|
| Hi David. Thanks for your answer. I normally don't have this issue but it came about when I made a complex stamp to use in a bolean to create windows on a building. I have since just flipped those offending faces and all is well on the farm again. |
|
Note: Log in to post. Create a new account here.